Five causes worth checking

Film breaks are rarely a film problem. In most cases the film is doing what it was asked to do, and something upstream is asking too much of it.

Check these five before you change supplier.

1. Tension. Film is stretched between the roll and the tray. If the tension setting is high because the wrap looked loose, the film is already near its limit before it touches the tray. Loosen the tension and check the wrap on a cooled pack rather than a warm one.

A ten-minute test that finds most of them

2. Roll alignment. A roll that is not sitting square pulls to one side. The film then rides against the edge of the guide and tears at the same point every time. Look for a tear that always appears in the same place; that is an alignment symptom, not a film fault.

3. Tray edges. Sharp corners, a chipped rim or a tray that is slightly too tall for the setting will cut film as it wraps. Run a hand around the tray rim. If it catches, the film will too.

4. Heat and cold. Film behaves differently in a cold room and a warm packing area. If breaks cluster at the start of a shift or after the chiller door has been open, temperature is in play. Let the film reach room temperature before running it.

When it really is the film

5. Film storage. Film stored in sunlight, near a heater, or on a pallet for a year is not the same film. Check the roll's age and how it has been stored, then test a fresh roll.

A ten-minute check that finds most of these: run ten packs, note where each break happens, then run ten more with the tension reduced by one step. If the pattern changes, it is a setting. If nothing changes, swap the roll and repeat.

One more thing worth checking: whether the film was changed recently. A new supplier with the same width but a different stretch behaviour will break at settings that used to work. When film changes, re-tune the machine rather than accepting the breaks.

If breaks continue after these checks, send us a short video of the machine running and a photograph of a broken pack. The tear pattern usually tells us which of the five it is.